Header

Save Energy

Power Bandit

Power Bandit

Tracker Training

House Entry

Ceiling and Floors

The Kitchen

The Energy Guide

The Bathroom

The Laundry Room

Other Rooms

Conserving Energy

Remember

The Environment

The Environment

Energy All Around

Where Does Garbage Go?

Reduce

Reuse

Recycle

Rethink

Location: Bathroom
Mission: Eliminate water waste

Most of the hot water used in the bathroom is used while taking a bath or shower. A short shower uses less water than a regular bath, but a long shower can use more water than a bath.

Save water either way by filling the tub less full for a bath and by taking shorter showers.

Save hot water by installing a low-flow shower head.

You can also save hot water by installing a cut-off switch on your shower head. This allows you to turn off the water while you soap up and use the shampoo. If you don't have a cutoff switch, simply turn off the water while you lather up!

And speaking of hot water, ask an adult to check the thermostat on your family's water heater. It should be set at about 120 degrees Fahrenheit if your family does not have a dishwasher, and 140 degrees Fahrenheit if your family does have a dishwasher. Setting the thermostat higher than this can scald!

Make sure the tub, shower, sink faucet and toilet are not leaking water. Repair any leaks because leaking water means higher bills. Even a small drip can really add up over the course of a day.Install an aerator on your faucet in the bathroom sink. Aerators are small screens that break the water into many small droplets and air. The Environmental Protection Agency reports that aerators can reduce water consumption by 60% while still giving a strong water flow.



When washing your face, turn off the water while you scrub, then turn it on again to rinse.

When brushing your teeth, turn off the water while you brush.

Remind the people who shave in your house to turn off the water while shaving. It saves water to put water in a small cup and rinse the razor in the cup instead of under running water.

Don't flush money down the drain!

The average toilet can use 5-7 gallons of water per flush. That's up to seven full large milk bottles per flush!

Knowing that each flush uses a lot of water, do not use the toilet as a trashcan. Put things such as tissues in the trashcan, not in the toilet.

Install a low-flow toilet to use less water.

 

 

 

 

 

Copyright 2011